Status/Control (DDI-11)
The DDI-11 (DataPort Line Out Adapter) component enables you to convert the output of one connector on a DataPort card installed in the Core, or an I/O Frame to two standard analog line out connections for use with a non-DataPort amplifier. The component in Q-SYS Designer represents a physical adapter cable available from QSC along with the installation instructions.
Note: Use the installation instructions under Alternate Uses in the DDI-11 Installation Guide.
This topic covers the use and configuration of the component in Q-SYS Designer.
When the DDI-11 is used, there is no control or telemetry available through the two associated DataPort card channels - they behave the same as a Line Out card. You must have the DDI-11 component in your design and wired to a DataPort component, and the DDI-11 adapter connected to the DataPort card for this feature to operate. If either is installed, and the other missing, the output is muted.
Inputs and Outputs
Input Pins
Amplifier signal pins are represented by a left-pointing (
) triangle, and the wiring is represented by a thin orange line. This component only has one input pin available.
Output Pins
This component has no output pins available.
Properties
Tip: For additional properties not listed, refer to the Properties Panel help topic for more information.
Controls
There is one set of the following controls for each channel.
Meter (dBu)
Measures the output level.
Mute
Mutes the output.
Invert
Inverts the output.
Gain (dB)
Sets the gain of the output.
Control Pins
There is one set of the following control pins for each channel.
|
Pin Name |
Value |
String |
Position |
Pins Available |
|---|---|---|---|---|
|
Gain |
-100 to 20 |
-100 dB to 20 dB |
0.000 to 1.00 |
Input / Output |
|
Invert |
0 1 |
normal invert |
0 1 |
Input / Output |
|
Meter |
-100 to 20 |
-100 dB to 20 dB |
0.000 1.000 |
Output |
|
Mute |
0 1 |
unmute mute |
0 1 |
Input / Output |
